Ryobi 18-Volt ONE+ Lithium-Ion Cordless PEX Tubing Clamp Tool (Model P660) – Reciprocating Saw
Category: Reciprocating Saws
Choose Ryobi 18-Volt ONE+ Lithium-Ion Cordless PEX Tubing Clamp Tool (Model P660) – Reciprocating Saw. The P660 delivers up to 400 clamps per P108 battery charge for fast, one-handed cycles. Reciprocating Saws such as Ryobi Reciprocating Saw replace manual pinch tools for consistent crimps.
Ryobi P660 performance vs rival PEX clamp tools: analysis
Ryobi 18-Volt ONE+ Lithium-Ion Cordless PEX Tubing Clamp Tool (Model P660) – Reciprocating Saw offers fast, repeatable cycles. The P660 uses a one-touch activation and LED status indicator to confirm each clamp cycle. Compared to hand pinch pliers, Model P660 Reciprocating Saw reduces variability from operator fatigue on long runs.
How do battery amperage and motor torque affect clamp speed?
Ryobi P660 delivers up to 400 clamps per P108 charge. Battery amp-hour (Ah) increases total cycles but not clamp speed; motor torque and drive gearing determine cycle time. Higher torque motors finish pinch cycles faster and handle larger rings without stall or rework. For example, P108-rated operation yields about 400 clamps per charge on moderate duty tasks.
Evaluating clamp styles, durability, and battery tradeoffs for PEX use
Ryobi 18-Volt ONE+ Lithium-Ion Cordless PEX Tubing Clamp Tool (Model P660) – Reciprocating Saw excels with stainless rings. Stainless bands resist corrosion better than plated steel or copper in most potable and outdoor settings. Clamping requires matching tool jaw profile to ring type; wrong matches cause poor seals and callbacks. Cordless tools trade peak hydraulic force for portability; battery runtime and motor gearing determine throughput.
Which clamp band material resists corrosion best on CPVC and PEX?
This Ryobi reciprocating saw pairs best with 316 stainless clamp bands for maximum corrosion resistance. 316 stainless resists chlorides, salt spray, and acidic soils better than 304 stainless in coastal installs. Copper clamps offer good compatibility but can cause galvanic corrosion when paired with dissimilar metals like steel. For typical backyard or CPVC transitions, 304 stainless is adequate; choose 316 for seaside or treated soil.
Buying decision checklist for Ryobi P660 and competing PEX clamps
Ryobi 18-Volt ONE+ Lithium-Ion Cordless PEX Tubing Clamp Tool (Model P660) – Reciprocating Saw lists near $151.95 tool-only. The reviewed Ryobi P660 reciprocating saw suits buyers owning RYOBI ONE+ batteries already. If you lack ONE+ batteries, factor in battery and charger cost or buy an included kit. Compare alternative systems by peak clamp force, cycle time, jaw compatibility, and warranty terms before purchase.
When does cordless convenience justify choosing a battery clamp tool?
P660 justifies purchase when you need hundreds of clamps without a compressor. Cordless clamp tools save setup time for remote yards, scaffolding, and tight attics. For occasional single repairs, manual pinch pliers or inexpensive crimpers reduce cost and tool clutter. Also weigh battery ecosystem value: RYOBI ONE+ works across 225 tools, improving long-term ROI.
How long does a P108 charge last: roughly 400 clamps per charge during moderate duty. Can the tool handle 1-inch stainless rings: yes, it fits 3/8-inch to 1-inch clamp sizes reliably. Should first-time buyers buy tool-only: buy bare tool only if you own ONE+ batteries; otherwise buy kit.